Kv2-audio EPAK2500R User Manual Page 1

ONES1.0 SYSTEM0-6dB-3 +3+6dBMASTER LEVEL1 PER SIDE2 PER SIDEHI FREQ LEVEL0-6dB-3 +3+6dBSUB LEVEL0-6dB-3 +3+6dBEXT SUB LEVELPOWER/SERVICEUNPROPERUSELIM

The Mid/Hi Insert point gives you the ability to ‘insert’ a signal processing device intothe ES 1.0 signal chain. For instance in some instances it ma

4USING THE SYSTEMTaking the following diagram as an example, if the ES 1.0 was ying you might wantto one ES 2.5 above it with the other two ES 1.8’s

EPAK 2500R AMPLIFIER / CONTROLLERSPECIFICATIONS5High Frequency Amplier SpecicationTypeClass AB Push-Pull low inter-modulation Mosfet design with tra

MAININPUTMAINAC INTHROUGHSIGNAL OUTCONTROLPREINPUTIMPEDANCEMID/HIINPUTPRE CONTROLOUTPUTINTERNALSUB INDISENGAGEENGAGEDISENGAGEENGAGE10kΩ50ΩDISENGAGEENG

WARRANTY, SERVICE & CONTACTINFORMATIONWARRANTYYour EPAK 2500R is covered against defects in material and workmanship.Refer to your supplier for mo

The future of sound.Made perfectly clear.KV2 Audio, Nádražní 936, 399 01 Milevsko, Czech RepublicTel. +44(0)1423 816868www.kv2audio.com KVV120030-00-0

IMPORTANT SAFETY INSTRUCTIONSBefore using your EPAK 2500R, be sure to carefully read the applicable items of theseoperating instructions and the safet

INDEX1. Introduction2. Getting Started2.1 Unpacking2.2 Rack Mounting2.3 Cooling2.4 AC Requirements3. Features3.1 Front panel3.2 Rear panel4. Usi

INTRODUCTIONThank you for purchasing this KV2 Audio EPAK 2500R unit. Thismanual contains important information on operating this unit correctly and

GETTING STARTED2.1 UNPACKINGUnpack the EPAK 2500R and check to see if there is any damage to it. If you anydamage notify your supplier immediately.

GETTING STARTED2.3 COOLINGThe EPAK 2500R has a comprehensive cooling system featuring chassis-sealed PCB boardmounting and shock mounted, speed contro

FEATURES1) AC Mains SwitchThe EPAK 2500R has a combination AC Mainsswitch/circuit breaker on the front panel. If theswitch shuts during normal use, p

FEATURES1) Main Input / Through Signal OutThis is the main system input connector withassociated ‘Through Signal Output’ connectorfor sending unproces

4USING THE SYSTEMThe EPAK 2500R is designed to actively power one ES 1.0 cabinet and associated subwoofersystems. For Normal Mode operation signal is